Input and Output Parameters¶
In this section, the list of model input and output parameters are going to be listed. The user can easily change the value of these parameters in the MATLAB/ Octave code. If not changed, the below default values would be used by the ShorelineS model.
Model Inputs¶
- S
- description:
the main structure that includes the default settings of the ShorelineS model
- units:
- default:
- min:
- max:
Simulation wave parameters:¶
- S.Hso
- description:
wave height
- units:
[m]
- default:
1
- min:
- max:
- S.phiw0
- description:
deep water wave angle
- units:
degrees
- default:
330
- min:
- max:
- S.spread
- description:
wave spreading (wave_dir from range: S.phiw0 +/- 0.5*S.spread)
- units:
degrees
- default:
90
- min:
- max:
- S.Wavecorr
- description:
?
- extension:
- default:
0
- min:
- max:
- S.ddeep
- description:
Waterdepth at the location of wave climate, corresponding with S.Hso
- units:
[m]
- default:
25
- min:
- max:
- S.dnearshore
- description:
Waterdepth at the ‘dynamic boundary’, corresponding with S.phif
- units:
[m]
- default:
8
- min:
- max:
- S.interpolationmethod
- description:
Method for interpolating wave data of multiple wave stations on the coast
- units:
- default:
‘alongshore_mapping’
- aletrnatives:
‘weighted_distance’
Simulation coastline definition:¶
- S.phif
- description:
Orientation of the foreshore [?N]; only relevant for ‘KAMP’, ‘MILH’ or ‘VR14’
- units:
(in degrees)
- default:
[]
- min:
- max:
- S.d
- description:
active profile height
- units:
[m]
- default:
10
- min:
- max: